In Your 2013 Nissan Rogue, there are two fuse panels. On the driver’s side of the car, the first one is under the dash. It is up against the firewall and above the air intake. It should be visible with its cover on. Under the driver’s side of the dash, near the pedal box, is where you’ll find the second fuse box. The car’s main electrical systems are controlled by the fuse panel in the engine compartment. The auxiliary devices, such as the lighting and stereo, are run by the interior. If you frequently experience fuse problems in Rouge, I advise checking the wires to make sure none are shorting out.
The 2013 Nissan Rogue has two fuse boxes. The first is under the hood, while the second is below the steering wheel under the dashboard.
In This Article...
Where is the Nissan Rogue’s passenger compartment fuse box?
On the driver’s side, under the dashboard, is the internal fuse box. The engine compartment houses two fuse boxes underneath the hood. On the passenger side, close to the battery, is where you’ll find the primary fuse box. Push the two tabs as instructed to open it.
Are there any AC relays in 2013 Nissan Rogue models?
It is in the IPDM’s engine compartment (intelligent power distribution module). It’s the fuse box behind the hood with a clever name. The 51st fuse must be operational because the relay is present.
Why isn’t the AC on my Nissan Rogue working?
A refrigerant leak, an electrical climate control issue, or an issue with the air conditioning compressor are the three most frequent causes of air conditioning problems in Nissan Rogue vehicles. A refrigerant leak might not be detected until the air conditioner stops blowing cold, though.
How is the fuse box under the dash opened?
On the driver’s and passenger’s side, under the dashboard, are the inside fuse boxes. Push the tab in the direction shown in the figure to open the secondary fuse box lid. The driver’s side of the engine compartment houses the main under-hood fuse box. Push the tabs as shown to open it.
Where is the fuse box for the passenger area?
Behind a trim panel on the right side of the passenger footwell is the fuse panel. Pull the trim panel toward you and swing it away from the side to remove it. Reinstall it by aligning the tabs with the panel’s grooves and pressing it close.
Does the engine have a fuse box?
Electrical parts like the brake system and electric motor are protected by the fuses under the hood. A lot of the panels surrounding the storage compartment must be taken off in order to access the fuses behind the hood. To help with removing and inserting fuses, fuse pliers are provided on the interior of the fuse box cover.
Where is the fuse for the dashboard?
To identify the fuses for your dashboard, consult your owner’s manual. The fuse box for the instrument panel is typically found inside the car, on the driver’s side.
The owner’s manual or the interior of the fuse box should contain a diagram that outlines the functions of each fuse.
Remove the fuse using needle-nose pliers, then check inside the clear portion of the end. The two prongs jutting out should be joined by a slender piece of metal. The fuse has blown if the thin metal is broken. (If the fuse is opaque, search for any burn marks or damage.)
Replace the blown fuse by either inserting a fresh one or by replacing the old one with the new one. Make sure the new fuse’s amperage is the same as the old fuse if you’re replacing it. Damage or even a fire may arise from not using the same amperage.
How many fuse boxes are there in my car?
Two fuse boxes are standard in most automobiles. One is used to safeguard engine parts such the cooling system, the anti-lock brake pump, and the engine control unit, and it is found in the engine compartment.
The location of the AC fuse
The fuse is a wire enclosed in a glass case that may be found in the disconnect box next to your air conditioner.
The fuse is a safety feature created to guard against electrical harm to your air conditioner.
The fuse sacrifices itself and blows up in the event of an electrical overload to break the circuit and save your air conditioner.
Why might there be a power overload? Your air conditioner is typically strained during the really hot summers. The AC ends up consuming more power than it can handle in order to chill more air.
What occurs if a fuse in your car blows?
If you own your automobile for a long enough period of time, you may anticipate that one or more of the automotive fuses will blow at some point.
Usually, a blown fuse merely results in a minor electrical issue with your automobile, such as the inability to use your radio, the loss of your turn signal, or the improper operation of some of your climate control functions. However, blown fuses might occasionally result in your automobile not starting.
What symptoms indicate a blown fuse?
The steps below can be used to examine and replace the externally accessible fuse found near the electrical cord of many electrical equipment used in the field of eye care (Figure 1).
Take the fuse out of the holder. The fuse holder cap may occasionally need to be unscrewed using a tiny screwdriver.
Examine the fuse wire. The fuse has to be replaced if there is a clear gap in the wire or if there is a dark or metallic stain inside the glass. Follow steps 4 and 5 if you can’t tell whether the fuse is blown. Go to step 6 if it is certain that the fuse has blown.
Connect one of the multimeter’s leads to the fuse’s end. Put the second lead on the fuse’s opposite end. The fuse is good if the reading falls within the range of 0 and 5 Ohms. A damaged or deteriorated fuse is indicated by a higher value. A blown fuse is unmistakably shown by the reading OL (Over Limit).
Replace the fuse with one that is identical if it has blown (see panel). Keep in mind the fuse amperage and voltage ratings, which need to be printed on the fuse (Figure 3) or on the panel label close to the fuse holder. Also take note of the size and if the fuse is a fast-blow or slow-blow kind. If the fuse or the piece of equipment does not have any markings, you must refer to the user guide for that particular gadget.
Do I have to unplug the batteries to change the fuse?
When changing fuses, should the battery be disconnected? Yes. Before you open or begin working on a fuse box, always make sure to turn off your car’s ignition and disconnect the battery.
How much will it cost to replace a fuse?
You’re probably right because fuses are used by the majority of your car’s electrical parts.
To fix an automobile fuse, the total cost of the parts and labor might be between $110 and $140.
The majority of fuses only cost $10 to $20, however hiring a professional to change your fuse will cost you extra labor. Call ahead to get a repair estimate because labor rates might range from $65 to $100 per hour depending on the company you visit. If you change the fuse yourself, you will simply have to pay for the parts.
Jerry can help you find other methods to save money after you’ve changed the fuse in your automobile. Jerry, a certified broker, undertakes all the legwork involved in obtaining affordable estimates from the most well-known insurance providers and purchasing new auto insurance. Jerry will even assist you with rescinding your prior coverage.
Where is the location of the power distribution box?
In the engine compartment is where you’ll find the power distribution box. It contains high-current fuses that guard against overloads of your car’s major electrical systems. Some functionalities need to be reset if the battery has been removed and reconnected.
What location is the gasoline relay?
The fuel pump relay can be found in either the fuse box in the engine compartment or, in most car models, anywhere under the dashboard.
A lengthy, black box that houses numerous fuses and relays, including a fuel pump relay, is typically found in the engine or dashboard fuse box. The locations of the fuel pump relays can vary depending on the vehicle.
For quick access to the precise location of the fuel pump relay, consult your repair manual.
How can I tell if the relay for my fuel pump is blown?
By far, this is the most typical sign of a bad fuel pump relay, but it’s also one of the most disregarded. People frequently assume that the problem is with the battery or the starter, but if the combustion chamber is empty of fuel, you will never be able to start the engine!
If you don’t hear a click in the fuse box when you turn the key on and your car won’t start, you might have a bad fuel pump relay.
How can a broken horn be diagnosed?
Horns on cars are located up front where they are exposed to rain and chemicals from the road. Once that spray enters the horn’s inside, it may short out the coil and cause the trumpet to stop working (and blow the fuse in the process). However, a broken “clock spring” under the steering wheel, a defective horn relay, a damaged wire, or a corroded ground are other potential causes of an inoperable horn. Checking the most likely suspects is done as follows.
beginning with the fuse. To find it, see the owner’s manual for your car. If the fuse is functioning properly, use a custom fused jumper to jump electricity directly to the horn (pictured here). With 16-gauge wire, two clamps, and an in-line fuse holder, you may create a fused jumper. Quickly touch the other end of the clamp to the positive battery connection after attaching one clamp to the horn’s terminal. The horn won’t work if the fuse blows. If the horn clicks, there might not be a good ground connection, which would cause the issue. Try re-powering the horn after cleaning the ground connection. The horn will need to be replaced if it still clicks.
If the horn functions when powered by a jumper, the issue is upstream. Try replacing the horn relay before wasting time looking for a damaged wire. If the relay functions, a much bigger issue exists. Bring it to a qualified car mechanic.
The fuel pump reset button is where?
The vehicle permits you to restart once it has determined that the systems are secure. On the right side of the luggage compartment, behind an access panel, is the switch that turns off the gasoline pump. On top of the fuel pump shut-off switch is a red reset button.
